
A burst pipe can release several hundred gallons an hour, so the water needs to be off and the extraction started the same day. Mold begins colonizing wet drywall and framing after about 24 hours. Alfa Restorations reaches Huntington in about 30 minutes, 24 hours a day. Call (516) 306-7749.
Huntington's burst pipes are a wind problem as much as a temperature one. The harbour funnels north and northwest wind straight up into the village, and sustained wind strips heat out of wall cavities far faster than still air at the same temperature. A north-facing exterior wall on Main Street or New York Avenue can sit fifteen degrees colder inside the cavity than the same wall on the south side of the house.
The village housing stock makes it worse. Pre-1930 construction around the village, Halesite and Lloyd Harbor means original plumbing routed through exterior walls with no insulation behind it, because none was used when these houses were built. Some of it is still galvanized steel, which corrodes from the inside, narrows, and then splits along a seam rather than failing at a pinhole.
Then there is what the water hits. These are plaster-and-lath houses with old-growth hardwood floors. Both hold bound water far longer than modern drywall and both read dry at the surface while still wet inside. A standard three-day dry-out on a Huntington village house is how plaster gets written off that could have been saved, and how a job comes back as a mold claim six weeks later. These need Class 4 specialty drying and a longer monitoring period.
The newer hillside developments in Huntington Station, Melville and Greenlawn have a different failure. Supply lines run through uninsulated attics to serve upstairs bathrooms, and when one of those lets go the water comes down through ceilings into two or three rooms at once.
Yes, in almost all cases. A burst pipe is sudden and accidental, which is exactly what a homeowners policy is for, and it is one of the most reliably covered losses there is. The policy normally covers both the water damage and the resulting repairs, though not always the failed pipe itself.
Two things can jeopardize a claim. The first is heat: most policies require you to maintain heat in the property, so a pipe that froze because the heating was off in an unoccupied house can be denied. The second is delay, because policies include a duty to mitigate, so damage that got worse while you waited may not be covered even though the burst itself was.
If the house is vacant or seasonally unoccupied, check the vacancy clause in your policy. Many reduce or exclude coverage after 30 or 60 days unoccupied.
About 30 minutes on average, any hour. We are based in Hauppauge and run crews across Nassau and Suffolk, so a burst pipe at 3am gets the same response as one at 3pm.
Shut the water off at the main first, so that if it has split, it does not flood when it thaws. Then warm the area gradually with the heating or a hair dryer, never a blowtorch or heat gun, and open the tap it feeds so water can move as it melts. If you cannot find the frozen section or the pipe is in a wall, call a plumber before it thaws rather than after.
Yes. We document the cause and extent, photograph and moisture-map before anything is removed, and bill insurance directly where coverage applies.
Usually, but not on a standard schedule. Plaster holds bound water and reads dry at the surface while the material behind the keys is still wet. We dry it with low-humidity equipment over a longer period and take readings from inside the wall cavity, not just the face, before we call it done.
Because water travels along joists and through insulation before it finds a place to come through. The stain marks where it exited, not where it spread. Thermal imaging and moisture meters routinely find the wet area to be several times the size of what you can see.
Water is still moving while you read this. Call (516) 306-7749 and we will be with you in about 30 minutes, any hour of the day or night. We extract, dry and document the loss, and we bill your insurance directly.